Encyclopedia … combined with a great Buyer's Guide!

Intracavity Pumping

Author: the photonics expert

Definition: pumping a laser or OPO with intracavity radiation from another laser

Categories: article belongs to category optical resonators optical resonators, article belongs to category nonlinear optics nonlinear optics, article belongs to category laser devices and laser physics laser devices and laser physics, article belongs to category methods methods

DOI: 10.61835/0we   Cite the article: BibTex plain textHTML   Link to this page   share on LinkedIn

It is common to optically pump a laser with light from another laser; for example, fiber lasers are usually pumped with laser diodes. A relatively unusual way of pumping, however, is to place its gain medium inside the laser resonator of its pump laser, rather than using the output beam of the pump laser. Typically, the laser gain medium absorbs only a quite limited fraction of the received pump light, allowing the pump laser still to work with a moderate amount of gain. Such an intracavity pumping arrangement can be a solution for cases where only a very limited amount of pump absorption is achieved, so that single-pass pumping would be inefficient. In some cases, it is also relevant to achieve a particularly high pump intensity in that away. Also, intracavity pumping allows for a rather compact setup.

Bulk lasers, made from discrete elements like a laser crystal and some mirrors, are best suited for intracavity pumping, as one can relatively easily place another laser crystal in the resonator (possibly combining them to a single crystal by diffusion bonding), as shown in Figure 1. The intracavity power is in most cases substantially higher than the power which could be coupled out with some output coupler mirror. One may then use laser mirrors which are highly reflecting at the wavelength of the pump laser, while one of them serves as the output coupler of the other laser. The pump absorption in the second crystal is usually the dominant loss for the pump laser.

Typically, the pump laser itself is pumped with one or several laser diodes, the radiation of which must be coupled in through some dichroic mirror (for end pumping) or from the side (for side pumping).

Figure 1: Example for an intracavity-pumped Yb:KYW laser. The pump laser is a 914-nm Nd:YLF laser.

Vertical external-cavity surface-emitting lasers could be similarly suitable for intracavity pumping of other lasers, except that the reflector which is integrated into the semiconductor gain chip may not be sufficiently broadband, or may then need to be specially optimized. Alternatively, one may use another intracavity mirror which does not allow the radiation of the laser to get to the semiconductor gain chip.

Intracavity pumping is also applied to some optical parametric oscillators (OPOs) [5] and Raman lasers, particularly to those for continuous-wave operation, where it is otherwise often challenging to reach the required high pump power.

In any case, the laser dynamics may exhibit special features related to relaxation oscillations due to the interplay of two lasers, or a laser and an intracavity-pumped OPO or Raman laser.

Example: Yb Laser in a Nd Laser Resonator

In some cases, an ytterbium-doped laser gain medium is used for laser emission on its zero-phonon line around 0.98 μm. As there is strong reabsorption at such a wavelength, such a laser requires operation with a rather high degree of excitation of the Yb3+ ions. One then requires pumping with a high intensity at a somewhat shorter wavelength, and typically has only quite limited pump absorption there. It is not possible to solve that problem by using more ytterbium in the system, as that would lead to strong amplified spontaneous emission (ASE) at longer wavelengths.

An elegant solution for efficient operation is then intracavity pumping, for example at 914 nm with a Nd:YVO4 laser [11].

Example: Ho Laser in Tm Laser Resonator

Holmium lasers are often used for generating laser light in the 2.1-μm region (somewhat longer than reachable with thulium-doped laser gain media). It is possible to do in-band pumping of holmium with 2-μm radiation from a thulium laser, for example a thulium-doped fiber laser. However, efficient pump absorption is not easy to achieve. A good solution can be to place the holmium-doped laser crystal within the laser resonator of a Tm:YLF laser or Tm:YAG laser [2, 12, 16, 17], which also results in a compact setup.

More to Learn

Encyclopedia articles:

Bibliography

[1]J. R. Ackerhalt et al., “Short-pulse intracavity Raman laser”, Opt. Lett. 13 (8), 646 (1988); https://doi.org/10.1364/OL.13.000646
[2]R. C. Stoneman and L. Esterowitz, “Intracavity-pumped 2.09-μm Ho:YAG laser”, Opt. Lett. 17 (10), 736 (1992); https://doi.org/10.1364/OL.17.000736
[3]F. G. Colville, M. H. Dunn and M. Ebrahimzadeh, “Continuous-wave, singly resonant, intracavity parametric oscillator”, Opt. Lett. 22 (2), 75 (1997); https://doi.org/10.1364/OL.22.000075
[4]D. J. M. Stothard, M. Ebrahimzadeh and M. H. Dunn, “Low-pump-threshold continuous-wave singly resonant optical parametric oscillator”, Opt. Lett. 23 (24), 1895 (1998); https://doi.org/10.1364/OL.23.001895
[5]M. Ebrahimzadeh et al., “Intracavity continuous-wave singly resonant optical parametric oscillators”, J. Opt. Soc. Am. B 16 (9), 1499 (1999); https://doi.org/10.1364/JOSAB.16.001499
[6]G. A. Turnbull et al., “Transient dynamics of CW intracavity singly resonant optical parametric oscillators”, IEEE J. Quantum Electron. 35 (11), 1666 (1999); https://doi.org/10.1109/3.798090
[7]R. Dabu, C. Fenic and A. Stratan, “Intracavity pumped nanosecond optical parametric oscillator emitting in the eye-safe range”, Appl. Opt. 40 (24), 4334 (2001); https://doi.org/10.1364/AO.40.004334
[8]Y. Zhong et al., “An efficient intracavity-pumped KTP optical parametric oscillator at 1572 nm”, Chin. Opt. Lett. 4 (11), 646 (2006)
[9]D. J. M. Stothard et al., “Stable, continuous-wave, intracavity, optical parametric oscillator pumped by a semiconductor disk laser (VECSEL).”, Opt. Express 17 (13), 10648 (2009); https://doi.org/10.1364/OE.17.010648
[10]J. Lin et al., “Study of relaxation oscillations in continuous-wave intracavity Raman lasers”, Opt. Express 18 (11), 11530 (2010); https://doi.org/10.1364/OE.18.011530
[11]F. Balembois et al., “Line competition in an intracavity diode-pumped Yb:KYW laser operating at 981nm”, J. Opt. Soc. Am. B 28 (1), 115 (2011); https://doi.org/10.1364/JOSAB.28.000115
[12]G. L. Zhu et al., “Ho:YAP laser intra-cavity pumped by a diode-pumped Tm:YLF laser”, Laser Physics 23 (1), 015002 (2013); https://doi.org/10.1088/1054-660X/23/1/015002
[13]Y. Duan et al., “Efficient RTP-based OPO intracavity pumped by an acousto-optic Q-switched Nd:YVO4 laser”, Opt. Lett. 39 (5), 1314 (2014); https://doi.org/10.1364/OL.39.001314
[14]P. J. Schlosser et al., “Intracavity Raman conversion of a red semiconductor disk laser using diamond”, Opt. Express 23 (7), 8454 (2015); https://doi.org/10.1364/OE.23.008454
[15]J. Zhao et al., “Diode-pumped actively Q-switched Tm:YAP/BaWO4 intracavity Raman laser”, Opt. Express 23 (8), 10075 (2015); https://doi.org/10.1364/OE.23.010075
[16]H. Huang et al., “Direct 800 nm diode-pumped Holmium laser with broad pump wavelength range and temperature adaptability”, Opt. Express 27 (9), 13492 (2019); https://doi.org/10.1364/OE.27.013492
[17]J. Gao et al., “12.7 W intra-cavity pumped Ho:YAG laser with near-diffraction-limited beam quality”, Opt. Express 31 (11), 17175 (2023); https://doi.org/10.1364/OE.486447

(Suggest additional literature!)

Questions and Comments from Users

Here you can submit questions and comments. As far as they get accepted by the author, they will appear above this paragraph together with the author’s answer. The author will decide on acceptance based on certain criteria. Essentially, the issue must be of sufficiently broad interest.

Please do not enter personal data here. (See also our privacy declaration.) If you wish to receive personal feedback or consultancy from the author, please contact him, e.g. via e-mail.

Spam check:

By submitting the information, you give your consent to the potential publication of your inputs on our website according to our rules. (If you later retract your consent, we will delete those inputs.) As your inputs are first reviewed by the author, they may be published with some delay.

preview

Share this with your network:

Follow our specific LinkedIn pages for more insights and updates: